![]() ![]() Tried to install RRAS on host to route traffic from virtual machines to another machines in the host-network but that didn't help. The latter is because I can't get in how would I route traffic from my Virtual network to my physical network. They don't see other physical computers located on the same network as the host. And my virtual machines can only connect to each other and their host. I also think that it's maybe that the MAC address when it's virtual machine is not getting saved on the network since I don't have a router on my physical machine. This property can be set to a value different from NMTERNARYDEFAULT (-1) only when the interface is configured in AP mode. The only thing is HOW TO DO THAT? Is it possible? NMTernary (int32) Configures AP isolation, which prevents communication between wireless devices connected to this AP. you can use many third-party tools to send a magic packet over the network containing the MAC address of the remote computer to wake. I want to start the VMs myself from anoher PC in the LAN remotely. WakeMeOnLan lets you scan your network at a time when all computers are powered up and it will collect all of their MAC addresses, saving the information to a file. ![]() To show you why it may be needed. Suppose another admin is sitting at the host and I don't want to bother him starting my VMs. While many Wake-on-LAN tools assume that you know the MAC address of any computer you want to remotely boot, this tool can help you with that. I want to wake those VMs (see the topic) to get them started.
0 Comments
Leave a Reply. |